This window serves for setting and performing the operation of transformation of coordinates of features of a map or its component. Work with the wizard is organized as a set of successive steps to each of which a separate wizard page corresponds. Going between steps is performed using buttons Next> and <Back.
Serves for selecting one of available transformation types and also gives the user a possibility to load values of transformation settings parameters saved before. | |
The page serves for creating a rollback file which permits undoing results of transformation of coordinates and restoring the map state before performing transformation. | |
Serves for specifying coordinates of control points determining particular transformation of coordinates. | |
Set transformation region and select features for transformation | Allows the user to determine which features should undergo transformation of coordinates. The whole map or specified polygonal region, all features or features of specified type or spatial category or only selected features can be selected. |
The page serves for specifying vertices of a polygon without self-intersections bounding the region on the map, features in which are subject to transformation of coordinates. | |
The page serves for selecting map feature types which should participate in the operation of transformation of coordinates. | |
The page serves for selecting spatial categories of features which should participate in the operation of transformation of coordinates. | |
The page is intended for selecting report file on the operation of transformation of coordinates and also for saving transformation parameters for repeated use. | |
Intended for performing the operation of transformation of coordinates after completing the settings. |
Next> | Proceeds to next wizard page |
<Back | Returns to previous wizard page |
Cancel | Cancels all made actions and closes the window. |
 |  |
