The page is intended for specifying export parameters and saving export settings file.
On this page the pane of parameters containing three pages with tabs is located and the pane “Settings file”.
Input fields Center X, Y, Width, Height and Slope serve for specifying center coordinates, width, height and slope angle of rectangular area specifying export region of map features.
Parameters Center, Width and Height are specified in map units. Parameter Slope is specified in degrees, positive value corresponds to counter-clockwise rotation, negative value – to clockwise rotation.
Originally these values in input fields determining export region correspond to the theme displayed fragment if export of a theme is performed, or if a map is exported – to map boundaries within which features are located. If export region parameters were changed, the button Default will reset them to initial values.
Only map features which at least partially fall into export region will be exported in DXF file.
Radio buttons located on page “Correspondence of Axes” allow selecting transformation of coordinate axes of ObjectLand map to coordinate axes of DXF file. In indications of radio buttons axes are shown by lower-case letters in ObjectLand map, by upper-case letters – in DXF file.
Radio buttons serve for setting export mode of linked table data to DXF file group indicated in the field Extra group. Modes set by them denote the following:
Do not export links – export of linked table data is not performed.
Export without diagnostics – export of linked table data is performed. However, if some errors appear during export, diagnostics is not put in report file;
Export with diagnostics – this mode is similar to the previous one with the exception that information about export errors is put in report file.
The drop-down list Extra group is used for specifying the code of DXF file group to which values linked with features of the corresponding type will be stored.
If the box Save settings is checked, the pane permits specifying a name of export settings file. To enter field name the button Browse should be pushed. A dialog box of saving a file will appear.
Cancel | Cancels performing the procedure. |
<Back | Cancels actions at the current step and returns to the previous step. |
Next> | Fixes actions performed at the current step and proceeds to next step of the procedure. |
Wizard of export of spatial data in DXF format
 |  |
