Dialog box "Parameters of hatch element"

The dialog box serves for changing parameters of hatch element: step, slope angle and section width.

Panes

Step	Serves for specifying the distance between displayed copies of hatch element. The step is specified in units of the editing pane corresponding to pixels of the screen.
Angle	Serves for specifying slope angle of hatch element. The angle is specified in degrees in counter-clockwise direction from the horizontal axis.
Section width	Serves for specifying section width. Width is specified in units of the editing pane.

Buttons

OK	Confirms changing parameters of hatch element.
Cancel	Cancels changing parameters of hatch element.