At this stage it is necessary to determine parameters not belonging to individual components of the source map, but to the operation as a whole. The corresponding page of the wizard is shown at the figure 52-6, using of its panes is described in the chapter 52 “Merging maps”, subsection “Setting parameters of the operation”.
It should be mentioned that default parameter values of the destination map are the same as in the source map (see chapter 9 “Map structure”).
Fields of the pane ”Parameters” permit the user to specify parameters of the destination map which are different from parameters of the source map. Transformation of the range and partition of the map in the course of copying will be performed much faster than if copying is performed at first, and then – changing map parameters.
 |  |
