Setting of copying components is the most important and difficult step of the procedure. At this step the page “Copying settings” is opened. It permits specifying the mode of processing every component of the map and of every component of GDB linked with the map.
The wizard page (figure 52-2) contains two panes: the pane of component types and the pane of components.
Figure 52-2. Page of copying wizard “Copying settings”
If no unresolved conflicts would been left after performing the setting, then after pushing the button Next the wizard will proceed to the next page.
If some components with Undefined processing modes would been left, the system will display a warning message and will not go further. One of those components for which the mode was not defined will be selected in the pane of components of the page “Copying settings”.
 |  |
