Import procedure is implemented using a wizard and consists of several steps. At each step it is required to make certain actions: select a name for import file, indicate which layers of DXF file to import, perform setting of import of layers, etc. The appropriate wizard page corresponds to each step:
first step – page “Select DXF file for import and load settings” (see chapter 61 “General characteristic of import/export operations”, subsection “Import”);
second step – page “Setting components”;
third step – page “Setting links of components”;
fourth step – page “Setting parameters”;
fifth step – page “Select report file” (see chapter 61 “General characteristic of import/export operations”, subsection “Report file”);
final step – page “Review settings”.
The main steps of import setting are described below.
 |  |
